ACCESSMASTER OL1010 OVERLOCK INSTALLATION MANUAL For Technical Support Please Call: 1-888-528-7826 www.chamberlainaccess.
Overlock Serial Number Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
Overlock Serial Number Unit Number Transceiver Serial Number CONTENTS Overview................................................................................................... 1 Specifications ........................................................................................... 1 Battery Power .......................................................................................... 2 Tools Required..........................................................................................
Overview The Overlock device is a battery-powered, radio-actuated, locking device that provides a positive stop to control unit access. An actuator is extended until it sits against a closed door hasp, providing a positive lock that effectively prevents the door from being opened. The Overlock provides additional access and security control that integrates with a Falcon XT access control system.
WARRANTY & DISCLAIMER Chamberlain Access Solutions warrants its products and equipment to conform to its own specifi cations and to be free from defects in materials and workmanship, under normal use and service, for a period of two years from the date of shipment. Within the warranty period, Chamberlain Access Solutions will repair or replace, at its option, all or any part of the warranted product which fails due to materials and/or workmanship.
5. After installation, the overlock and adapter should be positioned as follows. Mounting the Overlock After overlocks have been learned they can be installed on the units. During installation, keep track of the serial number of each overlock, the unit number on which it is installed, and the serial number of the transceiver to which it reports. This information will be needed when installing the software.
2. Add the cover bracket and the nylon or flange nut. Tighten until fitted snugly using a 1/4”drive ratchet with extension and a 7/16” socket. Cover Bracket 4. Slide the overlock toward the hasp until the end of the extended actuator touches the end of the hasp. Nylon or Flange Nut 3. When installation is complete, the adapter should be positioned as follows. NOTE: The actuator will not be visible from the front as the mounting bracket covers the actuator. 5.
7. Hold the overlock in position tight against the door and drill a 1/4" hole in the door through the top right hole. Drill hole in top right hole and insert rivet. 11. Test the actuator again after installation. Press the tamper switch (S3) located to the left of the battery case to retract the actuator arm. The actuator should be in the retracted position after installation. 12. Install the battery cover. Install all screws just until each one holds.
