User's Manual

Assembly

STEP 3 Install the idler pulley

1. Lay the beltbeside the rail,as shown. Grasp the end with the hooked trolley connector and pass

approximately 12" (30 cm) of belt through the window.Keep the ribbed side toward the rail,and

allow it to hang until AssemblyStep 4.

2. Remove the tape from the idler pulley.The inside center should be pre-greased. Ifdry, regrease

to ensure proper operation.

3. Place the idler pulley into the window as shown.

4. Insert the idler boltfrom the top through the rail and pulley.Tighten with a 3/8" lockwasher and

nut underneath the rail until the lock washer is compressed.

5. Rotate the pulley to be sure it spins freely.

6. Locate the rail tab.The rail tab is between the idler boltand the trolley in the front rail section. Use

a flathead screwdriver and liftthe rail tab until the tab is vertical (90º).

HARDWARE

Bolt

Nut 3/8"

Lock Washer 3/8"

Rail

Trolley Connector

Bolt

Lock Washer 3/8"

Nut 3/8"

Rail

Tab

CORRECT

INCORRECT

Rail Tab

Idler Pulley

Grease Inside Pulley