Installation Guide
Table Of Contents
- ENGLISH
- BILT Intelligent Instructions
- Installation Manual
- Contents
- Safety Symbol and Signal Word Review
- Preparation
- Assembly
- Installation
- STEP 1 Determine the Header Bracket Location
- STEP 2 Install the Header Bracket
- STEP 3 Attach the Rail to the Header Bracket
- STEP 4 Position the Garage Door Opener
- STEP 5 Hang the Garage Door Opener
- STEP 6 Install the Light Bulbs
- STEP 7 Attach the Emergency Release Rope and Handle
- STEP 8 Install the Door Bracket
- STEP 9 Connect the Door Arm to the Trolley
- STEP 10 Install the Door Control
- STEP 11 Wire the Door Control to the Garage Door Opener
- STEP 12 Attach the Warning Labels
- STEP 13 Install the Protector System®
- STEP 14 Wire the Safety Reversing Sensors
- STEP 15 Connect Power
- STEP 16 Align the Safety Reversing Sensors
- Adjustments
- Battery Backup
- myQ® App Control
- Operation
- Maintenance
- Troubleshooting
- Warranty
- Contact Information
- Automatic Garage Door Opener Safety & Maintenance Guide
- Repair Parts
29
Installation
STEP 14 Wire the Safety Reversing Sensors
If your garage has pre-installed wiring for the safety reversing sensors, see OPTION B - PRE-WIRED
INSTALLATION page 30.
OPTION A - INSTALLATION WITH NO PRE-WIRING
1. Run the wire from both sensors to the garage door opener. Attach with staples, but DO NOT puncture
the wire.
2. Separate the sensor wires and strip insulation from each end. Twist the two white wires together. Then
twist the two white/black wires together.
3. Using a screwdriver, push in the terminal tabs, and insert the white wires into the white terminal.
Insert the white/black wires into the grey terminal.
Staple
7/16" (11 mm)
WHITE
WHITE
GREY
RED
1
2
3
HARDWARE
Insulated Staple (Not Shown)