Installation Guide

39
Operation
Using your Door Control
MULTI-FUNCTION CONTROL PANEL
Command LED
LIGHT Button
LEARN Button
LOCK Button
Push Bar
SYNCHRONIZE THE DOOR CONTROL: To synchronize the door control
to the garage door opener, press the push bar until the garage door
opener activates (it may take up to 3 presses). Test the door control by
pressing the push bar; each press of the push bar will activate the
garage door opener.
PUSH BAR: Press the push bar to open or close the door.
LEARN BUTTON: Use to program compatible remote controls, wireless
keyless entries and myQ
®
devices to the garage door opener.
LOCK: Prevents remote controls from working, while still allowing
activation from the door control and keyless entry. (Factory setting is
OFF.)
Turn ON:
Press and hold the LOCK button for 2 seconds. The command LED will
flash as long as the lock feature is on.
Turn OFF:
Press and hold the LOCK button for 2 seconds. The command LED will
stop flashing and normal operation will resume.
LIGHT BUTTON: Turns the garage door opener lights on or off when
pressed. Lights stay on for 4-1/2 minutes (factory setting). The LIGHT
button will not control the lights when the door is in motion.
To change the amount of time the lights stay on:
Press and hold the LOCK button (approximately 10 seconds) until the
garage door opener lights flash. The time interval is indicated by the
number of times the garage door opener lights flash:
l 1 flash is 1-1/2 minutes
l 2 flashes is 2-1/2 minutes
l 3 flashes is 3-1/2 minutes
l 4 flashes is 4-1/2 minutes
To cycle through the time intervals repeat the step above. If the push
bar LED is continuously blinking, the LOCK feature needs to be turned
off.
To turn the Light feature on or off (Factory default is On):
Turn OFF:
1. Close the garage door.
2. Start with the garage door opener lights "OFF".
3. Press and hold the LIGHT button (approximately 10 seconds)
until the garage door opener lights turn off, then on again.
Turn ON:
1. Close the garage door.
2. Start with the garage door opener lights "ON".
3. Press and hold the LIGHT button (approximately 10 seconds)
until the garage door opener lights turn off, then on again.
PUSH BUTTON DOOR CONTROL
Push Button
LIGHT Button
SYNCHRONIZE THE DOOR CONTROL: To synchronize the door control
to the garage door opener, press the push button until the garage door
opener activates (it may take up to 3 presses).
PUSH BUTTON: Press the button to open or close the door.
LIGHT/LEARN BUTTON: Press the LIGHT button to turn the garage
door opener lights on or off. When the lights are turned on they will
stay on until the LIGHT button is pressed again, or until the garage door
opener is activated. Once the garage door opener is activated the lights
will turn off after the specified period of time (the factory setting is 4-
1/2 minutes). The LIGHT button will not control the lights when the door
is in motion.