Replacement Part List

39
Motion Sensor
Switch
LEARN Button
LOCK Button
LIGHT Button
Motion Sensor
Push Bar
Operation
Motion Detecting Control Panel
Command
LED
SYNCHRONIZETHEDOORCONTROL: To synchronize the door control to the garage door opener, press the push
bar until the garage door opener activates (it may take up to 3 presses). Test the door control by pressing the push
bar; each press of the push bar will activate the garage door opener.
PUSHBAR: Press the push bar to open or close the door.
LEARN BUTTON: Use to program compatible remote controls, wireless keyless entries and myQ® devices to the
garage door opener.
MOTION SENSOR: Turns the garage door opener lights on when motion is detected. Lights stay on for 4-1/2 minutes
(factory setting), then turn o. Set the motion sensor switch ON or OFF to control this feature.
LOCK: Prevents remote controls from working, while still allowing activation from the door control and keyless
entry. (Factory setting is OFF.)
Turn ON: Press and hold the LOCK button for 2 seconds. The command LED will ash as long as the lock feature
is on.
Turn OFF: Press and hold the LOCK button for 2 seconds. The command LED will stop ashing and normal
operation will resume.
LIGHTBUTTON:Turns the garage door opener lights on or o when pressed. Lights stay on for 4-1/2 minutes
(factory setting). The LIGHT button will not control the lights when the door is in motion.
To change the amount of time the lights stay on:
Press and hold the LOCK button (approximately 10 seconds) until the garage door opener lights ash. The time
interval is indicated by the number of times the garage door opener lights ash:
l 1 ash is 1-1/2 minutes
l 2 ashes is 2-1/2 minutes
l 3 ashes is 3-1/2 minutes
l 4 ashes is 4-1/2 minutes
To cycle through the time intervals repeat the step above. If the push bar LED is continuously blinking, the LOCK
feature needs to be turned o.
To turn the light feature ON (Factory default is On):
1. Close the garage door.
2. Start with the garage door opener lights "ON".
3. Press and hold the LIGHT button (approximately 10 seconds) until the garage door opener lights turn
o, then on again.
To turn the light feature OFF:
1. Close the garage door.
2. Start with the garage door opener lights "OFF".
3. Press and hold the LIGHT button (approximately 10 seconds) until the garage door opener lights turn
o, then on again.