Replacement Part List
Table Of Contents
- ENGLISH
- Contents
- Safety Symbol and Signal Word Review
- Preparation
- Assembly
- Installation
- STEP 1 Determine the Header Bracket Location
- STEP 2 Install the Header Bracket
- STEP 3 Attach the Rail to the Header Bracket
- STEP 4 Position the Garage Door Opener
- STEP 5 Hang the Garage Door Opener
- STEP 6 Attach the Emergency Release Rope and Handle
- STEP 7 Install the Door Bracket
- STEP 8 Connect the Door Arm to the Trolley
- STEP 9 Install the Door Control
- STEP 10 Wire the Door Control to the Garage Door Opener
- STEP 11 Attach the Warning Labels
- STEP 12 Install the Protector System®
- STEP 13 Wire the Safety Reversing Sensors
- STEP 14 Connect Power
- STEP 15 Align the Safety Reversing Sensors
- Adjustments
- Battery Backup
- myQ® App Control
- Camera
- Operation
- Maintenance
- Troubleshooting
- Warranty
- Automatic Garage Door Opener Safety & Maintenance Guide
- Repair Parts
6
Hardware x2 (each)
Wood Blocks
Extension Brackets – 041A5281-1
Preparation
Tools Needed Additional Items You May Need:
Survey your garage area to see if you will need any of the following items:
l (2) 2X4 Pieces of wood : May be used to fasten the header bracket to the structural supports.
Also used to position the garage door opener during installation and for testing the safety
reversing sensors.
l Support bracket and fastening hardware: Must be used if you have a nished ceiling in your
garage.
l Extensionbrackets(Model041A5281-1)orwoodblocks: Depending upon garage construction,
extension brackets or wood blocks may beneeded toinstall the safety reversing sensor.
Lag screws x4 Lag screws x12
l Fastening hardware: Alternate oor mounting of the safety reversing sensor will require hardware not
provided.
l Door reinforcement: Required if you have a light weight steel, aluminum, berglass or glass panel door.
l Railextensionkit: Required if your garage door is more than 7 feet (2.13 m) high.
3/16
7/16
1/2
5/32
5/16
9/16
1/4
7/16
l Hangingbrackets
l Supportbrackets