How to Guide

Operation

Using your Garage Door Opener

l The garage door opener can be activated with a wall-mounted door control,remote control,

wirelesskeylessentry, MyQ

Smartphone Control app or MyQ

Garage Door Monitor. When

the door is closed and the garage door opener is activated the door will open. Ifthe door

senses an obstruction or is interrupted while opening the door will stop. When the door is in

any position other than closed and the garage door opener is activated the door will close. If

the garage door opener senses an obstruction while closing, the door will reverse.If the

obstruction interrupts the sensor beam the garage door opener lights will blink 10 times.Ifthe

door is fully open, and the safetyreversing sensors are not installed, or are misaligned, the

door will not close from a remote control,TTC,or the MyQ

Smartphone Control app.

However, you can close the door by holding the button on the door control or the ENTER

button on the keylessentryuntil the door is fully closed.

l The garage door opener light bulbs will turn on when the opener is initially plugged in; power

is restored after interruption, or when the garage door opener is activated. The lightswill turn

offautomatically after 4-1/2 minutes. The lightswill turn on when someone enters through the

open garage door and the safetyreversing sensor infrared beam is obstructed, see page 35

(Motion Detecting Control Panel) or see page 37 (Multi-Function Control Panel). Use an

incandescent A19 light bulb (100 watt maximum) or for maximum energy efficiencya 26W

(100W equivalent) compact fluorescent light (CFL) bulb. NOTE: Do not use halogen, short

neck, or specialty light bulbs as these may overheat the end panel or light socket. Do not use

LED bulbs as they may reduce the range or performance of your remote controls.

To Open the Door Manually

To prevent possible SERIOUS INJURY or DEATH from a falling garage door:

l If possible, use emergencyrelease handle to disengage trolley ONLY when garage door is

CLOSED. Weak or broken springs or unbalanced door could result in an open door falling

rapidly and/or unexpectedly.

l NEVER use emergency release handle unlessgarage doorwayis clear of persons and

obstructions.

l NEVER use handle to pull door open or closed. Ifrope knot becomesuntied, you could fall.

DISCONNECT THE TROLLEY

1. The door should be fully closed if possible.

2. Pull down on the emergencyrelease handle so the trolley release arm snaps to the vertical

position. The door can now be raised and lowered as often as necessary.

TO RE-CONNECT THE TROLLEY

1. Pull the emergencyrelease handle toward the garage door opener so the trolley release arm

snaps to the horizontal position. The trolley will reconnecton the next UP or DOWN operation,

either manually or by using the door control or remote control.