Manualshelf

How to Guide

ManualsBrandsChamberlain ManualsBuilding SuppliesChamberlain Group B550 Smartphone-Controlled Ultra-Quiet & Strong Belt Drive Garage Door Opener with MED Lifting Power Blue
31323334353637383940
38
Operation
TIMER-TO-CLOSE (DO NOT enable on one-piece doors)
The Timer-to-Close feature is not available on all door controls.Below is a listof door controls with the
Timer-to-Close feature:
041A7305-1 Smart Control Panel and 041A7327-1 Motion Detecting Control Panel
The Timer-to-Close feature automatically closes the garage door after a specified time period. DO NOT
enable TTC if operating a one-piece door. TTC is to be used ONLY with sectional doors. Factory
default is set to off.The garage door opener will beep and the lightswill flash before closing the door.
The TTC feature will deactivate if the garage door encounters an obstruction twice; or the safety
reversing sensors are incorrectly installed. The garage door will reverse open and WILL NOT close
until the obstructions are clear or the safetyreversing sensors are correctly installed. When the
obstruction has been cleared or the safetyreversing sensors have been aligned, the door will close
when the garage door opener is activated. TTC WILL NOT work if the garage door opener is operating
by battery power or if the safetyreversing sensors are misaligned. This feature is NOT intended to be
the primary method of closing the door. A keyless entry should be installed in the event of an
accidental lock out when using this feature.
Remote Control and Keyless Entry
Pre-programmed remote control included, no need to program the remote.
To add or reprogram a remote control, follow the instructions below.Older Chamberlain remote
controls are NOT compatible, see page 43 for compatible accessories.
PROGRAM USING THE DOOR CONTROL
1. Pressthe LEARN button on the door control to enter Programming Mode.
2. Pressthe LEARN button again, the LED will flash once.
3. Remote Control: Pressthe button on the remote control that you wish to operate your garage
door.
Keyless Entry: Enter a 4-digit personal identification number (PIN) of your choice on the
keyless entrykeypad. Then press the ENTER button.
The garage door opener lightswill flash (or two clickswill be heard) when the code has been
programmed.
The command LED will flash once.
or
The command LED will flash once again.1 2
OR
PIN
? ? ? ?
3
or
To watch a video, go to tinyurl.com/lcsf6xt
HomeLink
®
If your vehicle is equipped with HomeLink,a CompatibilityBridge
TM
(not included) may be necessary for
certain vehicles. Visitbridge.chamberlain.com to find out if a Bridge is needed.