How to Guide

Assembly

STEP 2 Fasten the rail to the motor unit

To avoid SERIOUS damage to garage door opener, use ONLY those bolts/fasteners mounted in the

top of the opener.

1. Insert a 1/4"-20 x 1-3/4" bolt into the cover protection bolt hole on the backend of the rail as

shown. Tighten securely with a 1/4"-20 locknut.DO NOT overtighten.

2. Remove the boltsfrom the top of the motor unit.

3. Use the carton to support the front end of the rail.

4. Place the “U” bracket,flat side down onto the motor unit and align the bracket holes with the

bolt holes.

5. Fasten the “U” bracket with the previouslyremoved bolts; DO NOT use any power tools.The

use of power tools may permanently damage the garage door opener.

Bolt

1/4"-20x1-3/4"

Lock Nut

1/4"-20

HARDWARE

“U” Bracket

Cover Protection

Bolt Hole

Bolt 1/4"-20x1-3/4"

Lock Nut 1/4"-20

Bolts (Mounted in the

garage door opener)