Instructions / Assembly

Installation

STEP 11 Wire the door control to the garage door opener

1. Run the white and red/white wire from the door control to the garage door opener. Attach the

wire to the wall and ceiling with the staple (not applicable for gang box or pre-wired

installations).Do not pierce the wire with the staple as this may cause a short or an open

circuit.

2. Strip 7/16 inch (11 mm) of insulation from the end ofthe wire near the garage door opener.

3. Connectthe wire to the red and white terminals on the garage door opener. If your garage is

pre-wired make sure you use the same wires thatare connected to the door control. To insert

or release wires from the terminal, push in the tab with screwdriver tip.

RED

WHITE

GREY

7/16" (11 mm)

HARDWARE

Insulated Staple (Not Shown)

Staple

STEP 12 Attach the warning labels

1. Attach the entrapment warning label on the wall near the door control with tacks or staples.

2. Attach the manual release/safetyreverse test label in a visible location on the inside ofthe

garage door.