User Manual

35
Operation
Multi-Function Control Panel
SYNCHRONIZE THE DOOR CONTROL: To synchronize the door control to the garage door opener,
press the push bar until the garage door opener activates (it may take up to 3 presses).Test the door
control by pressing the push bar; each pressof the push bar will activate the garage door opener.
Push Bar
LIGHT Button
LOCK Button
Command LED
LEARN Button
PUSH BAR: Pressthe push bar to open or close the door.
LIGHT BUTTON: Press the LIGHTbutton to turn the garage door opener lightson or off.When the
lights are turned on they will stay on until the LIGHTbutton is pressed again, or until the garage door
opener is activated. Once the garage door opener is activated the lightswill turn offafter the specified
period of time (the factory default is 4-1/2 minutes). The LIGHTbutton will not control the lightswhen the
door is in motion. The Light Feature will turn on the light on the garage door opener when someone
enters through the open garage door and the safetyreversing sensor infrared beam is obstructed.
To change the amount of time the lightsstay on:
Press and hold the LOCK button (approximately 10 seconds) until the garage door opener lights flash.
The time interval is indicated by the number of times the garage door opener lightsflash:
l 1 flash is 1-1/2 minutes
l 2 flashes is 2-1/2 minutes
l 3 flashes is 3-1/2 minutes
l 4 flashes is 4-1/2 minutes
To cycle through the time intervals repeat the step above. Ifthe push bar LED is continuously blinking,
the LOCK feature needs to be turned off.
To turn the Light feature on or off (Factory default is On):
Turn OFF:
1. Close the garage door.
2. Startwith the garage door opener lights"OFF".
3. Press and hold the LIGHTbutton (approximately 10 seconds) until the garage door opener
lights turn off,then on again.
Turn ON:
1. Close the garage door.
2. Startwith the garage door opener lights"ON".
3. Press and hold the LIGHTbutton (approximately 10 seconds) until the garage door opener
lights turn off,then on again.
LEARN BUTTON: Any compatible remote control, wireless keyless entry, or MyQ
®
devices can be
programmed to the garage door using the LEARN button.
LOCK: Preventsthe garage door opener from being activated by remote controls while still allowing
activation from the door control and keyless entry.
Turn ON:
Press and hold the LOCK button for 2 seconds.The command LED will flash as long as the lockfeature
is on.
Turn OFF:
Press and hold the LOCK button for 2 seconds.The command LED will stop flashing and normal
operation will resume.