User Manual
Table Of Contents
- Owner’s Manual C450
- Preparation
- Assembly
- Installation
- STEP 1 Determine the header bracket location
- STEP 2 Install the header bracket
- STEP 3 Attach the rail to the header bracket
- STEP 4 Position the garage door opener
- STEP 5 Hang the garage door opener
- STEP 6 Install the light bulbs
- STEP 7 Attach the emergency release rope and handle
- STEP 8 Install the door bracket
- STEP 9 Connect the door arm to the trolley
- STEP 10 Install the door control
- STEP 11 Wire the door control to the garage door opener
- STEP 12 Attach the warning labels
- STEP 13 Install the Protector System®
- STEP 14 Wire the Safety Reversing Sensors
- STEP 15 Connect power
- STEP 16 Aligning the safety reversing sensors
- STEP 17 Ensure the door control is wired correctly
- Adjustments
- MyQ® Smartphone Control
- Operation
- Maintenance
- Troubleshooting
- Accessories
- Warranty
- Repair Parts
- SPANISH
38
Maintenance
Maintenance Schedule
EVERY MONTH
l Manually operate door. Ifit is unbalanced or binding, call a trained door systemstechnician.
l Check to be sure door opens and closes fully. Adjust if necessary, see page29.
l Testthe safetyreversal system. Adjust if necessary, see page31.
EVERY YEAR
l Oil door rollers, bearings and hinges.The garage door opener does not require additional
lubrication. Do not grease the door tracks.
The Remote Control Battery
To prevent possible SERIOUS INJURY or DEATH:
l NEVER allow small children near batteries.
l If battery is swallowed, immediately notify doctor.
To reduce riskof fire, explosion or chemical burn:
l Replace ONLY with 3V CR2032 coin batteries.
l DO NOT recharge, disassemble, heat above 212°F (100°C) or incinerate.
The 3V CR2032 Lithium battery should produce power for up
to 3 years.If the battery is low, the remote control’s LED will
not flash when the button is pressed.
To replace battery,pry open the case firstin the middle (1),
then at each side (2 and 3) with the visor clip. Replace the
batteries with only 3V CR2032 coin cell batteries. Insert
battery positive side up. Dispose of old batteries properly.
1
2
3
NOTICE:To complywith FCC and/orIndustryCanada (IC)rules,adjustment ormodificationsof thistransceiverare prohibited. THERE
ARENOUSER SERVICEABLEPARTS.
Thisdevice complieswith Part15 of the FCC rulesand IC RSS-210. Operation issubjectto the following two conditions:(1)thisdevice
maynot causeharmfulinterference, and (2)thisdevice must accept anyinterferencereceived, including interference that maycause
undesired operation.
Thisdevice mustbe installed in a waywhere a minimum8"(20 cm)distanceismaintained between users/bystandersand device.
AVIS:Lesrèglesde laFCC et/ou d’Industrie Canada (IC)interdisent tout ajustement ou toute modification de cerécepteur.IL
N’EXISTEAUCUNEPIÈCESUSCEPTIBLED’ÊTREENTRETENUEPARL’UTILISATEUR.
Cet appareilestconforme auxdispositionsde lapartie 15 du règlement de laFCC et de l'norme IC RSS-210. Son utilisation est
assujettieauxdeuxconditoinssuivantes: (1)ce dispositif ne peut causerdesinterférencesnuisibles,et (2)cedispositif doitaccepter
toute interférencerecue, ycomprisune interférencepouvant causerun fonctionnement non souhaité.
Cet appareildoit être installéde manière à laisserune distance d’au moins20 cm(8 po)entre celui-ciet l’utilisateurou toute personne.