Instructions / Assembly

21
Installation
STEP 10 Install the door control
To preventpossible SERIOUS INJURY or DEATHfrom electrocution:
l Be sure power is NOTconnected BEFORE installing door control.
l Connectdoor control ONLY to 12 VOLT low voltage wires.
To preventpossible SERIOUS INJURY or DEATHfrom a closing garage door:
l Install door control within sight of garage door, out of reach ofsmall children at a minimum
heightof5feet(1.5m) above floors, landings,steps or anyother adjacentwalking surface, and
away from ALL moving parts of door.
l NEVER permit children to operate or playwith door control push buttonsor remote control
transmitters.
l Activate door ONLY when itcan be seen clearly, is properly adjusted,and there are no
obstructionsto door travel.
l ALWAYS keep garage door in sight until completelyclosed. NEVER permit anyone to cross
path ofclosing garage door.
INTRODUCTION
Compatible with MyQ
®
enabled accessories, see page 41. Your garage door opener is compatible with
up to 2 MyQ
®
door controls. NOTE: Older Chamberlain door controls and third party products are not
compatible.
Install the door control within sight ofthe door at a minimumheight of 5 feet(1.5 m) above floors,
landings,steps or anyother adjacentwalking surface, where small children cannot reach, and away
fromthe moving parts of the door. For gang boxinstallations itisnotnecessaryto drill holesor install the
drywall anchors.Use the existing holesin the gang box.
NOTE: Your product may look different than the illustrations.
Screw
6ABx1" (2)
Drywall
Anchors (2)
Screw
6-32x1" (2)
HARDWARE
1. Strip 7/16 inch (11 mm) of insulation from one end of the wire and separate the wires.
2. Connect one wire to each ofthe two screwson the back of the door control. The wires can be
connected to either screw.Ifyour garage is pre-wired for the door control choose anytwo
wires to connect,note which wires are used so the correctwires are connected to the garage
door opener in a later step.
3. Mark the location ofthe bottommounting hole and drill a 5/32 inch hole.
4. Install the bottomscrew, allowing 1/8 inch (3 mm) to protrude from the wall.
5. Position the bottomhole of the door control over the screw and slide down into place.
6. Lift the push bar up and mark the top hole.
7. Remove the door control from the wall and drill a 5/32 inch hole for the top screw.
8. Position the bottomhole of the door control over the screw and slide down into place. Attach
the top screw.
7/16" (11 mm)
Wall
1
2 3
DRYWALL
GANG BOX
6AB x 1"
6-32 x 1"
Drywall Anchor
4-5
6
6-32 x 1"
GANG BOX
8
DRYWALL
6AB x 1"
Drywall Anchor
7