User Manual

Installation

STEP 14 Wire the Safety Reversing Sensors

If your garage already has wires installed for the safety reversing sensors, proceed to page 25.

OPTION A INSTALLATION WITHOUT PRE-WIRING

1. Run the wire from both sensors to the garage door opener. Attach the wire to the wall and

ceiling with the staples.

2. Strip 7/16 inch (11 mm) of insulation from each set of wires.Separate the wires.Twistthe white

wires together. Twistthe white/blackwires together.

3. Insert the white wires into the white terminal on the garage door opener. Insert the white/black

wires into the grey terminal on the garage door opener. To insert or remove the wires from the

terminal, push in the tab with a screwdriver tip.

Staple

7/16" (11 mm)

WHITE

GREY

RED

HARDWARE

Insulated Staple (Not Shown)