Telephone Keypad Programming Guide
Page 6
Programming Basics
Programming Single Unit Overview
Programming Single Unit Overview
1 1, 2 or 3 digit Programming Number.
(See “
Quick Reference Guide
” Tables for descriptions and procedures)
2 One or more Data Fields.
3 Pound Key (#) as a Data Field Separator and at the
end
of the programming sequence to
Save the Data
.
•
•
•
•
EL25 Keypad: You may use the keypad on the front panel. (Next Page)
Local/Remote DTMF Phone: You may use the keypad on a local or remote phone to program the system. The unit
responds to the DTMF signals generated by your touch-tone phone. (Next Page)
Direct/Modem Connection to a PC: In order to program the EL25 with a direct or modem connection, your PC must be
running Sentex's Windows
®
-compatible Versa XS software. (Not covered in this Quickstart Guide)
1
st
Pound Key:
Separates the 1
st
field.
Last Pound Key:
Saves the data.
Data Field:
1 changes the password
(2 verifies the password)
Data Field:
(The new password)
Programming Number:
changes or verifies
the password.
Enter
Programming
Mode
(Next page)
Exit
Programming
Mode
(Next page)
The EL25 can be programmed
3
different ways.
1
2
3
THIS guide will outline some programming for the EL25 from the keypad or
local/remote DTMF (Touch-Tone) phone ONLY.
For more information, refer to the Manuals and/or your installation dealer.
All data fields must be separated with the pound key (#).
( Programming Number) # (Data Field) # (Data Field) # (Data Field) #
Steps tagged with a (
) are
optional
, press the pound key (#) to skip them. Note: Some steps are
required
and
must
have data entered in them to continue, tagged with ( ).
If you make an error during an entry, press the asterisk key (
*
) to cancel the step.
When you
correctly
enter the
entire
programming sequence, the unit will respond with
2
short beeps
(see also System Feedback/Responses (Beeps)).
If you make an error during an entry, press the asterisk key (
*
) to begin again.
Notes:
Example of a Programming Sequence: “
Changing the Password”
Pound Key:
Separates the data field.
Programming Single Unit Overview
1
1
Procedure Required to Program the EL25:
#
#
2 short
beeps
1 3 4
2
Optional StepRequired Step Required Step Required Step
Example:
Required Step
Optional Step,
Press (
#
) to Skip.