Installation and operating instructions for HomEntry garage door opener Model HE60R Chamberlain Australia Pty Ltd Phone toll free 1800 638 234 Fax toll free 1800 888 121 Chamberlain New Zealand Ltd Phone toll free 0800 637 546 Fax toll free: 0800 653 663 www.homentry.com.au This manual contains IMPORTANT SAFETY information. DO NOT PROCEED WITH THE INSTALLATION BEFORE READING THOROUGHLY.
0
Start by Reading These Important Safety Instructions WARNING: Failure to comply with the following instructions may result in serious personal injury or property damage. • Read these instructions carefully and follow ALL instructions carefully • The garage door opener is designed and tested to offer reasonable safe service provided it is installed and operated in strict accordance with the instructions in this manual.
1 Carton Inventory 1. Instruction manual (this document) 2. Stop bracket collar 3. Clamp bracket 4. Release handle and cord 5. Remote controls (2) 6. Extension poles (2) 7. Weight bar 8. Bracket plate 9. Hardware bag 10. Warning Labels (2) 2 Tools Required 1. Ladder (or similar device to safely support door weight) 2. Adjustable wrench for U-bolts already installed on the door 3. 8mm socket, 10mm socket and 13mm extended socket and socket wrench 4.
3 Door Requirements The maximum allowable door height is 3.5m with a maximum curtain area of 8m² (door height in metres multiplied by the width in metres). The maximum allowable door weight is 60kg. Door area; h x w = m2 eg. 2.5 x 3 = 7.5m2 Minimum side room installation Typical side room installation Ensure that there is at least 45mm from the edge of the curtain to the edge of the bracket.
4 Testing the door Disable all locks and remove any ropes connected to the garage door. Complete the following test to ensure your door is well balanced, and not sticking or binding: • Lift the door to about halfway and then release it. The door should remain suspended entirely by its spring. • Raise and lower the door to discover if there are any sticking or binding points.
Preparing the Opener Set Opener Position (Left or Right hand) For left hand side installations the wire jumper should be removed. For right hand side installations the wire jumper should be in place (factory installed). Attaching the Extension Poles (if required) • Insert the extension poles into the gear. • Align the extension pole holes with the gear holes. • Using the supplied screws secure the extension poles. Place the Opener in Manual Release mode.
Installation steps FOR RIGHT HAND INSTALLATIONS (REFER SECTION 7, page 5) • Ensure that the opener position jumper (wire connector) is installed (refer Section 7, page 5). • Place the opener in manual release mode (refer Section 7, page 5). • Open the roller door fully. For safety, tie a rope around the door. Ensure that the U-bolt on the left hand side of the door is secure. • Mark the position of the door shaft on the right hand door bracket.
Attach the Release Handle and Cord • Thread one end of the rope through the hole in the top of the red handle so “NOTICE” reads right side up as shown. Secure with an overhand knot at least 25mm from the end of the rope to prevent slipping. • Thread the other end of the rope through the loop of the manual release cable. • Adjust rope length so the handle is no higher than 1.8m above the floor. Secure with an overhand knot. If the door is greater than 2.
12 Setting the Limits The Travel Limits regulate the points at which the door will stop when moving UP or DOWN. During the SetUp procedure, the motor will run and operate the door. The Opener must be fully installed on the door and all installation steps completed before proceeding. Make sure the door is clear of obstruction. Ensure your hands are away from any moving parts before activating the door. Position the door about half way and Engage the motor. (Section 10 page 7).
13 Setting the Force The force, as measured on the closing edge of the door, should not exceed 400N (40kg). If the closing force is measured to more than 400N, the Protector System must be installed. See Section 16. The force setting regulates the amount of power required to open and close the door. • Door should be closed. • Press the PURPLE button twice to enter opener into Force Adjustment Mode. The indicator LED will flash quickly (The Courtesy LEDs dim).
16 Install the Protector System™ (Safety Beams) Install this accessory for all installations where the closing force as measured on the bottom of the door is over 400N (40kgf). After opener has been installed and adjusted, The Protector System™ accessory can be installed. Instructions are included with this accessory. The Protector System™ provides an additional measure of safety against a small child being caught under a garage door.
18 Special Features • Multi function Control Panel Connect white/red wire to the red quick connect terminal and the white wire to the white quick connect terminal. • The Protector System™ (Safety Beams) Connect both white wires to the white quick connect terminal and both white/black wires to the grey quick connect terminal. 19 Motorlift/ HomEntry Compatible Accessories 1. 2. 3. 4.
Troubleshooting 1. The opener doesn't operate from either the GREEN start button or the remote controls: • Does the opener have electric power? Plug a lamp into the outlet. If it doesn't light, check the fuse box. • Have you disabled all door locks? Review installation instruction warnings on page 1. • Is there a build-up of ice or snow under the door? The door may be frozen to the ground. Remove any restriction. • The garage door spring may be broken. Have it replaced. 2.
MAINTENANCE OF YOUR OPENER SPECIFICATIONS HE60R Once a Month: Input Voltage: 230-240VAC, 50Hz, 85W • Repeat safety reverse test. Make any necessary adjustments (see pages 8 & 9). Rated Load: 15Nm Max.Pull Force: 450N Max. Door Weight 60kg Idle Current: less than 25mA @ 230VAC Drive: DC gearmotor permanent lubrication OPERATION OF YOUR OPENER Max. Drum Rotations: 5 Your opener can be activated by any of the following devices: Memory Registers: 64 Operating Frequency: 433.
CHAMBERLAIN LIMITED WARRANTY HomEntry HE60R Roller Door Operator Chamberlain Australia Pty Limited / Chamberlain New Zealand Limited (Seller) warrants to the original purchaser of the Chamberlain HE60R Roller Door Operator (Unit) that it is free from defects in material and/or workmanship for a period of 2 YEARS from the date of first purchase from the Seller Please retain your proof-of-purchase in the unlikely event you require warranty service.
