Owner's Manual
Table Of Contents
- Owner's Manual
- CONTENTS
- Preparation
- Assembly
- Installation
- STEP 1 Determine the header bracket location
- STEP 2 Install the header bracket
- STEP 3 Attach the rail to the header bracket
- STEP 4 Position the garage door opener
- STEP 5 Hang the garage door opener
- STEP 6 Install the light bulbs
- STEP 7 Attach the emergency release rope and handle
- STEP 8 Install the door bracket
- STEP 9 Connect the door arm to the trolley
- STEP 10 Install the door control
- STEP 11 Wire the door control to the garage door opener
- STEP 12 Attach the warning labels
- STEP 13 Install the Protector System®
- STEP 14 Wire the Safety Reversing Sensors
- STEP 15 Connect power
- STEP 16 Ensure the safety reversing sensors are aligned
- Adjustments
- Battery Backup
- Operation
- Maintenance
- Troubleshooting
- Accessories
- Warranty
- Contact Information
- Repair Parts
- SPANISH
2
Additional Items You May Need:
Survey your garage area to see if you will need anyof the following items:
n
(2) 2X4 PIECES OF WOOD
Maybe used to fasten the header bracket to the structural supports.Also used to position the
garage door opener during installation and for testing the safetyreversing sensors.
n
SUPPORT BRACKET AND FASTENING HARDWARE
Must be used if you have a finished ceiling in your garage.
n
EXTENSION BRACKETS (MODEL 41A5281) OR WOOD BLOCKS
Depending upon garage construction, extension brackets or wood blocksmaybe needed to
install the safetyreversing sensor.
n
FASTENING HARDWARE
Alternate floor mounting ofthe safety reversing sensor will require hardware not provided.
n
OUTSIDEQUICKRELEASE (MODEL 7702CB)
Required for a garage with NO access door.
n
DOOR REINFORCEMENT
Required if you have a lightweightsteel,aluminum,fiberglassor glass panel door.
n
RAIL EXTENSION KIT
Required if your garage door is more than 7 feet (2.13 m) high.
Tools Needed
2
1
3/16
7/16
1/2
5/32
5/16
5/8
9/16
1/4
7/16
Preparation