Owner's Manual
Table Of Contents
- Owner's Manual
- CONTENTS
- Preparation
- Assembly
- Installation
- STEP 1 Determine the header bracket location
- STEP 2 Install the header bracket
- STEP 3 Attach the rail to the header bracket
- STEP 4 Position the garage door opener
- STEP 5 Hang the garage door opener
- STEP 6 Install the light bulbs
- STEP 7 Attach the emergency release rope and handle
- STEP 8 Install the door bracket
- STEP 9 Connect the door arm to the trolley
- STEP 10 Install the door control
- STEP 11 Wire the door control to the garage door opener
- STEP 12 Attach the warning labels
- STEP 13 Install the Protector System®
- STEP 14 Wire the Safety Reversing Sensors
- STEP 15 Connect power
- STEP 16 Ensure the safety reversing sensors are aligned
- Adjustments
- Battery Backup
- Operation
- Maintenance
- Troubleshooting
- Accessories
- Warranty
- Contact Information
- Repair Parts
- SPANISH
40
Operation
Remote Control (continued)
PROGRAM A REMOTE CONTROL USING THE LEARN BUTTON
1. Locate the Learn Button.
2. Press and immediately release the Learn button. The Learn LEDwill glowsteady for 30
seconds. Within 30 seconds...
3. Press and hold the button on the remote control that you wish to use.
Release the button when the garage door opener lightsblink or two clicksare heard.
When replacing the light lenscover, ensure the antenna wires are hanging straightdown.
LEARN LED
LEARN
Button
“click”
“click”
1
2
To Erase the Memory
ERASE ALL REMOTE CONTROLS AND KEYLESS ENTRIES
1. Press and hold the learn button on garage door opener until the learn LEDgoes out
(approximately 6 seconds). All remote control and keyless entry codes are nowerased.
Reprogram any accessoryyou wish to use.
ERASE ALL DEVICES (Including MyQ
®
enabled accessories)
1. Press and hold the learn button on garage door opener until the learn LEDgoes out
(approximately 6 seconds).
2. Immediatelypressand hold the learn button again until the learn LED goes out. All codes are
now erased.
Reprogram any accessoryyou wish to use.
To Open the Door Manually
To preventpossible SERIOUS INJURY or DEATH from a falling garage door:
• If possible, use emergency release handle to disengage trolley ONLY when garage door is
CLOSED. Weak or broken springs or unbalanced door could result in an open door falling
rapidly and/or unexpectedly.
• NEVER use emergency release handle unless garage doorwayis clear of persons and
obstructions.
• NEVER use handle to pull door open or closed.Ifrope knotbecomesuntied,you could fall.
DISCONNECT THE TROLLEY
1. The door should be fully closed ifpossible.
2. Pull down on the emergency release handle so the trolley release arm snaps to the vertical
position.The door can now be raised and lowered as often asnecessary.
NOTICE
RECONNECT THE TROLLEY
1. Pull the emergency release handle toward the garage door opener so the trolley release arm
snaps to the horizontal position.
The trolley will reconnecton the nextUP or DOWNoperation, either manuallyor byusing the
door control or remote control.
N
O
TICE