User's Manual

39
Operation
Remote Control
Your remote controlhas been programmed at the factory to operate with your garage door opener.
Older Chamberlain remote controls are NOT compatible, see page 44 for compatible accessories.
Programming can be done through the door control or the learn button the garage door opener. To
program additional accessories refer to the instructions provided with the accessoryor visit
www.chamberlain.com. Ifyour vehicle is equipped with a Homelink
®
, you may require an external
adapter depending on the make,model,and year of your vehicle.Visitwww.homelink.com for additional
information.
TO ADD, REPROGRAM, OR CHANGE A REMOTE CONTROL/KEYLESS ENTRY PIN
USING THE MOTION-DETECTING CONTROL PANEL
1. Press the LEARN button on the door control to enter Programming Mode.
2. Press the LEARN button again, the LED will flash once.
3. Remote Control:
Press the button on the remote control that you wish to operate your garage door.Keyless
Entry: Enter a 4-digit personal identification number (PIN) ofyour choice on the keyless entry
keypad. Then pressthe ENTER button.
The garage door opener lights will flash (or two clickswill be heard) when the code has been
programmed. Repeat the steps for programming additional remote controls or keyless entry devices.
The command LED
will flash once.
The command LED will
flash once again.
1
2
OR
PIN
? ? ? ?
4
GHI
5
JKL
7
P
RS
8
TUV
9
WXY
0
QZ
*
#
E
NT
E
R
0 QZ
*
#
ENTER
6
MNO
3
TO ADD, REPROGRAM, OR CHANGE A REMOTE CONTROL/KEYLESS ENTRY PIN
USING THE SMART CONTROL PANEL
1. Press the navigation button below "MENU" to view the Features menu.
2. Use the navigation buttons to scroll to "PROGRAM".
3. Select "REMOTE" or "KEYPAD" to program fromthe program menu.
4. Remote Control:
Press the button on the remote control that you wish to operate your garage door.Keyless
Entry:
Enter a 4-digit personal identification number (PIN) of your choice on the keyless entry keypad.
Then pressthe ENTER button.
The garage door opener lights will flash (or two clickswill be heard) when the code has been
programmed. Repeat the steps for programming additional remote controls or keyless entry devices. If
programming is unsuccessful, program the remote using the learn button.
Press to continue.
TO REMOTE
Press to continue.
1
2 3
OR
PIN
? ? ? ?
4
GHI
5
JKL
7
P
RS
8
TUV
9
WXY
0
QZ
*
#
E
NT
E
R
0 QZ
*
#
ENTER
6
MNO
4