User's Manual

40
Operation
Remote Control (continued)
PROGRAM A REMOTE CONTROL USING THE LEARN BUTTON
1. Locate the Learn Button.
2. Press and immediately release the Learn button. The Learn LED will glow steady for 30 seconds.
Within 30 seconds...
3. Press and hold the button on the remote control thatyou wish to use.Release the button when
the garage door opener lightsblink or two clicksare heard. When replacing the light lens cover,
ensure the antenna wires are hanging straightdown.
LEARN LED
LEARN
Button
“click”
“click”
1
3
2
To Erase the Memory
ERASE ALL REMOTE CONTROLS AND KEYLESS ENTRIES
1. Press and hold the learn button on garage door opener until the learn LED goes out
(approximately 6 seconds).All remote control and keyless entry codesare now erased.
Reprogram any accessory you wish to use.
ERASE ALL DEVICES (Including MyQ
®
enabled accessories)
1. Press and hold the learn button on garage door opener until the learn LED goes out
(approximately 6 seconds).
2. Immediately press and hold the learn button again until the learn LED goes out. All codes are
now erased.
Reprogram any accessory you wish to use.
To Open the Door Manually
To preventpossible SERIOUS INJURY or DEATHfrom a falling garage door:
l
If possible,use emergency release handle to disengage trolley ONLY when garage door is
CLOSED. Weak or broken springs or unbalanced door could resultin an open door falling
rapidly and/or unexpectedly.
l
NEVER use emergency release handle unless garage doorway is clear of persons and
obstructions.
l
NEVER use handle to pull door open or closed.If rope knotbecomes untied, you could fall.
DISCONNECT THE TROLLEY
1. The door should be fully closed if possible.
2. Pull down on the emergencyrelease handle so the trolley release arm snaps to the vertical
position. The door can now be raised and lowered as often asnecessary.
TO RECONNECT THE TROLLEY
1. Pull the emergencyrelease handle toward the garage door opener so the trolley release arm
snaps to the horizontal position.The trolley will reconnect on the nextUP or DOWN operation,
either manually or by using the door control or remote control.