Instructions / Assembly

Installation

STEP 5 Hang the garage door opener

To avoid possible SERIOUS INJURY from a falling garage door opener, fasten it SECURELY to

structural supportsof the garage. Concrete anchors MUST be used if installing ANY bracketsinto

masonry.

Hanging the garage door opener will vary depending on your garage. Below are three example

installations.Your installation may be different.For ALL installations the garage door opener MUST be

connected to structural supports.The instructions illustrate one of the examples below.

Finished

Ceiling

Unﬁnishe

Ceiling

HARDWARE

Hex Bolt 5/16"- 18x7/8"

Nut 5/16"-18

Lock

Washer

5/16"-18

Lag Screw 5/16"-9x1-5/8"

1. On finished ceilings, use the lag screwsto attach a supportbracket (not provided) to the structural

supports before installing the garage door opener.

2. Make sure the garage door opener is aligned with the header bracket.Measure the distance

from each side of the garage door opener to the supportbracket.

3. Cut both pieces of the hanging bracket to required lengths.

4. Attach the end of each hanging bracket to the supportbracket with appropriate hardware (not

provided).

5. Attach the garage door opener to the hanging bracketswith the hex bolts,lockwashers,and

nuts.

6. Remove the 2x4 and manually close the door. Ifthe door hits the rail, raise the header bracket.

Finished

Ceiling

(not provided)

Lag Screw

5/16"-

9x1-5/8"

Lag Screw

5/16"-

9x1-5/8"

(not

provided)

Hex Bolt

5/16"- 18x7/8"

Nut 5/16"-18

Lock Washer

5/16"-18