Manualshelf

Instructions / Assembly

ManualsBrandsChamberlain ManualsDoors & Windows1-1/4 HPS Smartphone-Controlled Wi-Fi Belt Drive Garage Door Opener with Battery Backup and Ultra-Quiet Operation
11121314151617181920
14
Installation
STEP 6 Install the light bulbs
To preventpossible OVERHEATING of the end panel or light socket:
l Use ONLY A19 incandescent (100W maximum) or compactfluorescent(26W maximum) light
bulbs.
l DO NOT use incandescent bulbs larger than 100W.
l DO NOT use compact fluorescent light bulbs larger than 26W (100W) equivalent.
l DO NOT use halogen bulbs.
l DO NOT use short neckor specialty light bulbs.
1. Pull on the top sides ofthe light lens and rotate the light lens down.
2. Insert an A19 incandescent (100W maximum) or compactfluorescent (26W, 100W equivalent)
light bulb into the light socket.
3. Rotate the lens up to close.
NOTE: Do not use halogen, short neck, or specialty light bulbs as these may overheat the end panel or
light socket. Do not use LED bulbs as they may reduce the range or performance of your remote controls.
or
or
STEP 7 Attach the emergency release rope and handle
To preventpossible SERIOUS INJURY or DEATH from a falling garage door:
l If possible, use emergencyrelease handle to disengage trolley ONLY when garage door is
CLOSED. Weak or broken springs or unbalanced door could resultin an open door falling
rapidly and/or unexpectedly.
l NEVER use emergencyrelease handle unless garage doorway is clear of persons and
obstructions.
l NEVER use handle to pull door open or closed. Ifrope knot becomes untied, you could fall.
1. Insert one end of the emergencyrelease rope through the handle. Make sure that “NOTICE” is
right side up. Tie a knot atleast 1 inch (2.5 cm) from the end ofthe emergencyrelease rope.
2. Insert the other end ofthe emergencyrelease rope through the hole in the trolley release arm.
Mount the emergencyrelease within reach,butat least6 feet (1.83 m) above floor, avoiding
contact with vehicles to prevent accidental release and secure with a knot.
NOTE: If it is necessary to cut the emergency release rope, seal the cut end with a match or lighter to
prevent unraveling. Ensure the emergency release rope and handle are above the top of all vehicles to
avoid entanglement.