Instructions / Assembly

35
Operation
MENU OPTIONS (CONTINUED)
TIMER-TO-CLOSE (TTC) (Factory default is set to off): The Timer-to-Close feature automatically
closesthe door after a specified time period and can be adjusted using the door control. DO NOT enable
TTC if operating a one-piece door.TTC is to be used ONLY with sectional doors.The garage door
opener will beep and the lights will flash before closing the door. The TTC feature will deactivate if the
garage door encounters an obstruction twice;or the safetyreversing sensors are incorrectly installed.
The garage door will reverse open and WILL NOT close until the obstructions are clear or the safety
reversing sensors are correctly installed. When the obstruction has been cleared or the safetyreversing
sensors have been aligned, the door will close when the garage door opener is activated. TTC WILL
NOTwork if the garage door opener is operating by battery power or if the safetyreversing sensors are
misaligned. This feature is NOT intended to be the primary method of closing the door. A keyless entry
should be installed in the event of an accidental lockoutwhen using this feature.
To turn TTC on or offor to set the TTC time interval:
1. SelectTTC from the menu.
2. Selecta time interval of 1, 5, 10 minutesor a custom setting up to 99 minutes. Once the TTC has
been setand the door is open,a message will display on the screen with the selected time
interval.
To temporarily suspend the TTC feature selectHOLD.Select REL to resume normal TTC operation.
PROGRAM: Any compatible remote control, wireless keylessentry, or MyQ
®
devices can be
programmed to the garage door using the PROGRAM option from the menu.
Remote Control and Keyless Entry
Your remote control has been programmed at the factory to operate with your garage door opener,
randomly accessing over 100 billion new codes with each use. Your garage door opener can be
programmed with up to 8 remote controls,1 keyless entry, 2 Security+ 2.0™ door controls and 6 MyQ
®
accessories.Older Chamberlain remote controls are NOT compatible, see page 40 for compatible
accessories.
Programming can be done through the door control or the learn button on the garage door opener. To
program additional accessories refer to the instructions provided with the accessory or visit
www.chamberlain.com.If your vehicle is equipped with a Homelink
®
, you mayrequire an external
adapter depending on the make,model, and year of your vehicle.Visit www.homelink.com for additional
information.
TO ADD, REPROGRAM, OR CHANGE A REMOTE CONTROL/KEYLESS ENTRY PIN
USING THE DOOR CONTROL
1. Pressthe navigation button below "MENU" to view the Features menu.
2. Use the navigation buttons to scroll to "PROGRAM".
3. Select"REMOTE" or "KEYPAD" to program from the program menu.
4. Remote Control: Press the button on the remote control that you wish to operate your garage
door.
Keyless Entry: Enter a 4-digit personal identification number (PIN) of your choice on the keyless
entry keypad. Then press the ENTER button.
The garage door opener lightswill flash (or two clickswill be heard) when the code has been
programmed. Repeatthe steps for programming additional remote controls or keyless entry devices.If
programming is unsuccessful, repeat the steps using the learn button on the garage door opener.
1
2 3
OR
PIN
?
? ? ?
4
Press
to continue.
Press
to continue.