Instructions / Assembly

5
Assembly
STEP 1 Assemble the rail and install the trolley
To preventINJURY from pinching,keep hands and fingers away from the joints while assembling the
rail.
To avoid installation difficulties, do not run the garage dooropener untilinstructed to do so.
The front rail has a cut out “window” at the door end. The rail tab MUST be on top of the rail when
assembled.
1. Remove the straight door arm and hanging bracket packaged inside the front rail and set aside
for Installation Step 5 and 9. NOTE: To prevent INJURY while unpacking the rail carefully remove
the straight door arm stored within the rail section.
2. Align the rail sections on a flat surface as shown and slide the tapered ends into the larger ones.
Tabs along the side will lockinto place.
3. Place the motor unit on packing material to protectthe cover,and rest the backend of the rail on
top. For convenience,put a support under the front end ofthe rail.
4. Asa temporary stop, inserta screwdriver into the hole in the second rail section from the motor
unit, as shown.
5. Checkto be sure there are 4 plastic wear pads inside the inner trolley.If they became loose
during shipping,check all packing material. Snap them backinto position as shown.
6. Slide the trolley assembly toward the screwdriver as shown.
7. Slide the rail onto the “U” bracket, until itreaches all the stops on the top and sides of the “U”
bracket.
To garage
door opener
(TO MOTOR UNIT)
Front Rail
Section
(TO DOOR)
“U” Bracket
Outer Trolley
Inner Trolley
Wear Pads
SLIDE TO STOPS
ON TOP AND
SIDES OF
“U” BRACKET
Trolley
Rail Tab