Manualshelf

Installation Instructions

ManualsBrandsChamberlain ManualsGarage Door OpenersChamberlain LW5000EV
11121314151617181920
15
Installation
STEP 6 Install the light bulbs
To preventpossible OVERHEATING of the end panel or lightsocket:
l
Use ONLY A19 incandescent (100W maximum) or compact fluorescent (26W maximum) light
bulbs.
l
DO NOT use incandescent bulbs larger than 100W.
l
DO NOT use compact fluorescent light bulbs larger than 26W (100W) equivalent.
l
DO NOT use halogen bulbs.
l
DO NOT use short neck or specialty light bulbs.
1. Pull on the top sides ofthe lightlensand rotate the lightlensdown.
2. Insert an A19 incandescent(100W maximum) or compact fluorescent (26W, 100W equivalent)
lightbulb into the lightsocket.
3. Rotate the lensup to close.
NOTE: Do not use halogen, short neck, or specialty light bulbs as these may overheat the end panel or
light socket.Do not use LED bulbs as they may reduce the range or performance of your remote controls.
or
or
STEP 7 Attach the emergency release rope and handle
To preventpossible SERIOUS INJURY or DEATHfrom a falling garage door:
l
If possible,use emergency release handle to disengage trolley ONLY when garage door is
CLOSED. Weak or broken springs or unbalanced door could resultin an open door falling
rapidly and/or unexpectedly.
l
NEVER use emergency release handle unless garage doorway is clear of persons and
obstructions.
l
NEVER use handle to pull door open or closed.If rope knotbecomes untied, you could fall.
1. Insert one end of the emergency release rope through the handle. Make sure that“NOTICE” is
rightside up.Tie a knot at least1 inch (2.5 cm) from the end of the emergency release rope.
2. Insert the other end of the emergencyrelease rope through the hole in the trolley release arm.
Mount the emergencyrelease within reach, but at least 6 feet(1.83 m) above floor, avoiding
contact with vehicles to prevent accidental release and secure with a knot.
NOTE: If it is necessary to cut the emergency release rope, seal the cut end with a match or lighter to
prevent unraveling. Ensure the emergency release rope and handle are above the top of all vehicles to
avoid entanglement.