Instructions / Assembly

7
Overview
Set Up Your Smart Garage
Control
What you Need
Connect Your Smart Garage Control
Check Your Wi-Fi Signal
Pair the Door Sensor to the Hub
Mount the Door Sensor
Choose the Hub Location
Mount the Hub
How-To Video
Add myQ Smart Partners and
Accessories
Need Help?
Accessories and Parts
Set Up Your Smart Garage Control
Pair the Door Sensor to the Hub
The myQ App will pair the door sensor to the hub during initial set up.
Pair a second door sensor
To add a door sensor to a second garage door opener, in the myQ App tap
(+) to add a door sensor. Follow the instructions in the app.
Pair a replacement door sensor
To replace an existing door sensor follow the steps below.
1. The existing sensor is programmed to the hub as door 1 or door 2.
Press the test button on the existing door sensor. The hub beeps
one time if the sensor is door 1, and twice if door 2.
2. On the hub, press the button for door 1 or 2, corresponding to the
number of beeps heard. The LED lights solid amber.
3. Remove the pull tab from the new door sensor to activate the
battery.
4. Press and release the test button. The hub will ash and beep
indicating successful programming.
Mount the Door Sensor
Mount the door sensor (top facing up) with the included hook and loop
adhesive strips or optional screws to a clean, dry area on top panel of
garage door as shown. Test the door sensor battery every 6 months.
Hook and
loop adhesive
strips
Pry with coin
or screwdriver
OR
Mounting location
Make sure
“TOP” faces up
Hub
Door
Sensor
Test Button
Pull Tab
Amber LED
Door 1 Button
Door 2 Button