User's Manual

1
Carton InventoryOverview
The Wireless Doorbell and Intercom can determine who is at the
door from anywhere in the house. The doorbell and intercom have
up to a 1000 foot (300 m) range and use a 900 MHz secure digital
radio link. The intercom is compatible with various Chamberlain
Wireless Products. The doorbell and intercom can be programmed
to create a new network or add to an existing network.
THEORY OF OPERATION
To place a call to the intercom press the call button on the front
of the doorbell. To answer the call press and hold the talk button
on the intercom. Once the call is answered, a secure connection
is made between the two devices. The call button on the doorbell
does not need to be pressed to talk, however the talk button on
the intercom must be held to talk. Release the talk button to hear a
response. After 30 seconds of inactivity the doorbell and intercom
will time out and the call is ended. If a call is not answered within
30 seconds the intercom/doorbell will time out. Refer to the
Operation section for more information.
Models NDIS and NDISC
WIRELESS DOORBELL AND INTERCOM
HOLD
ACTIVE
TAL K
13
24
VOLUME
MONITOR
CHANNEL
OFF
Mounting Tape
Alcohol Wipe
Rubber Pads
Intercom
Doorbell
Assemble
Install 4 AA Alkaline batteries
(not provided). (Lithium
batteries recommended for
colder environments.)
DOORBELL
Program Doorbell to Intercom to Create New Network
Press and hold the learn button
on the intercom until a beep is
heard.
M
ON
I
T
OR
H
O
L
D
O
F
F
1
3
2
4
VO
L
U
ME
T
A
L
K
A
C
T
IV
E
Within 10 seconds press and
hold the Learn button on the
doorbell until a beep is heard.
INTERCOM
Install 4 AA Alkaline batteries
(not provided).
Adhere rubber pads to bottom.
1
2
1
Wait about 30 seconds for the
devices to sync, then test by
pressing the call button on the
doorbell. The call will be heard
on the intercom. Press and hold
the talk button on the intercom
to answer the call.
NOTE: If after pressing the
call button a connection is not
made, wait until the devices
have timed out and try again.
To create a new network between the intercom and doorbell follow the steps below. To add the intercom and doorbell into an existing
network refer to the "Program Intercom and Doorbell into Existing Network" section on the following page.
M
ONITO
R
HO
L
D
O
F
F
1
3
2
4
V
OL
U
ME
T
A
L
K
A
CTI
V
E
OPTIONAL
NOTE: A DC Adapter (not provided)
can also be used to power the
intercom. In this case, the channel
lights will remain on.
V
OL
U
ME
MONI
T
O
R
C
HAN
NE
L
HOL
D
O
F
F
A
CTI
V
E
T
A
L
K
1
3
2
4
1
2
3
Repeat Steps 1 and 2 for any
additional intercoms.