Instructions / Assembly

Installation

STEP 11 Wire the door control to the garage door opener

HARDWARE

Ins

ulated

Staple

(Not Shown)

1. Run the white and red/white wire from the door control to the garage door opener.Attach the

wire to the wall and ceiling with the staple (notapplicable for gang boxor pre-wired

installations).Do notpierce the wire with the staple as this maycause a short or an open

circuit.

2. Strip 7/16 inch (11 mm) ofinsulation from the end of the wire near the garage door opener.

3. Connectthe wire to the red and white terminalson the garage door opener.If your garage is

pre-wired make sure you use the same wires that are connected to the door control. To insert

or release wires from the terminal,push in the tab with screwdriver tip.

Staple

RED

WHITE

GREY

7/16" (11 mm)

STEP 12 Attach the warning labels

1. Attach the entrapment warning label on the wall near the door control with tacks or staples.

2. Attach the manual release/safety reverse test label in a visible location on the inside ofthe

garage door.