Operation Manual
Table Of Contents
- Owner's Manual
- CONTENTS
- Preparation
- Assembly
- Installation
- STEP 1 Determine the header bracket location
- STEP 2 Install the header bracket
- STEP 3 Attach the rail to the header bracket
- STEP 4 Position the garage door opener
- STEP 5 Hang the garage door opener
- STEP 6 Install the light bulbs
- STEP 7 Attach the emergency release rope and handle
- STEP 8 Install the door bracket
- STEP 9 Connect the door arm to the trolley
- STEP 10 Install the door control
- STEP 11 Wire the door control to the garage door opener
- STEP 12 Attach the warning labels
- STEP 13 Install the Protector System®
- STEP 14 Wire the Safety Reversing Sensors
- STEP 15 Connect power
- STEP 16 Ensure the safety reversing sensors are aligned
- STEP 17 Ensure the door control is wired correctly
- Adjustments
- Operation
- Maintenance
- Troubleshooting
- Accessories
- Warranty
- Contact Information
- Repair Parts
- Spanish
1
Safety Symbol and Signal Word Review
This garage door opener has been designed and tested to offer safe service provided it is installed,
operated, maintained and tested in strictaccordance with the instructions and warnings contained in this
manual.
When you see these Safety Symbols and Signal Words on the following pages,theywill alertyou to the
possibilityofserious injury or death if you do not comply with the warnings that accompanythem. The
hazard may come from something mechanical or from electric shock.Read the warnings carefully.
Mechanical
Electrical
When you see thisSignal Word on the following pages,itwill alertyou to the possibilityofdamage to
your garage door and/or the garage door opener if you do notcomply with the cautionarystatements that
accompanyit. Read them carefully.
Check the Door
To preventpossible SERIOUSINJURYor DEATH:
• ALWAYS call a trained door systems technician if garage door binds,sticks,or is outof balance.
An unbalanced garage door mayNOT reverse when required.
• NEVER try to loosen, move or adjustgarage door, door springs, cables,pulleys,bracketsor their
hardware, ALLofwhich are under EXTREMEtension.
• Disable ALLlocks and remove ALLropes connected to garage door BEFORE installation and
operating garage door opener to avoid entanglement.
To preventdamage to garage door and opener:
• ALWAYS disable locks BEFORE installing and operating the opener.
• ONLY operate garage door opener at120 V, 60 Hzto avoid malfunction and damage.
1. Disable locks and remove any ropes connected to the garage door.
2. Liftthe door halfway up.Release the door. If balanced, it should
stay in place,supported entirely by itssprings.
3. Raise and lower the door to checkfor binding or sticking. If your
door binds, sticks, or is out of balance,call a trained door systems
technician.
4. Check the seal on the bottom of the door. Any gap between the
floor and the bottom of the door must notexceed 1/4 inch (6 mm).
Otherwise,the safetyreversal system may notwork properly.
5. The opener should be installed above the center ofthe door. If
there isa torsion spring or center bearing plate in the way of the
header bracket,itmaybe installed within 4 feet (1.2 m) to the left or
rightof the door center. See page 13.
Torsion
Spring
Extension
Spring
OR
Preparation