Operation Manual
Table Of Contents
- Owner's Manual
- CONTENTS
- Preparation
- Assembly
- Installation
- STEP 1 Determine the header bracket location
- STEP 2 Install the header bracket
- STEP 3 Attach the rail to the header bracket
- STEP 4 Position the garage door opener
- STEP 5 Hang the garage door opener
- STEP 6 Install the light bulbs
- STEP 7 Attach the emergency release rope and handle
- STEP 8 Install the door bracket
- STEP 9 Connect the door arm to the trolley
- STEP 10 Install the door control
- STEP 11 Wire the door control to the garage door opener
- STEP 12 Attach the warning labels
- STEP 13 Install the Protector System®
- STEP 14 Wire the Safety Reversing Sensors
- STEP 15 Connect power
- STEP 16 Ensure the safety reversing sensors are aligned
- STEP 17 Ensure the door control is wired correctly
- Adjustments
- Operation
- Maintenance
- Troubleshooting
- Accessories
- Warranty
- Contact Information
- Repair Parts
- Spanish
30
Adjustments
STEP 2 Test the Safety Reversal System
Without a properly installed safetyreversal system, persons (particularlysmall children) could be
SERIOUSLY INJURED or KILLED bya closing garage door.
• Safety reversal system MUSTbe tested every month.
• After ANY adjustments are made, the safetyreversal system MUSTbe tested. Door MUST reverse
on contact with 1-1/2" (3.8 cm) high object(or 2x4 laid flat) on the floor.
1. With the door fully open, place a 1-1/2 inch (3.8 cm) board (or a 2x4 laid flat) on the floor,
centered under the garage door.
2. Press the remote control push button to close the door. The door MUSTreverse when itmakes
contact with the board.
If the door stopsand does not reverse on the obstruction, the down travel needs to be increased (refer to
Adjustment Step 1).Repeat the test.When the door reversesupon contactwith the 1-1/2 inch board,
remove the board and open/close the door 3 or 4 timesto test the adjustment. Ifthe garage door opener
continues to fail the safetyreversal test,call a trained door systems technician.
1 2
STEP 3 Test the Protector System
®
Without a properly installed safety reversing sensor, persons (particularly small children) could be
SERIOUSLY INJURED or KILLED by a closing garage door.
1. Open the door. Place the garage door opener carton in the path of the door.
2. Press the remote control push button to close the door. The door will not move more than an
inch (2.5 cm),and the garage door opener lightswill flash 10 times.
The garage door opener will not close from a remote control if the LED in either safety reversing sensor
is off(alerting you to the factthat the sensor is misaligned or obstructed).If the garage door opener
closes the door when the safetyreversing sensor is obstructed (and the sensors are no more than 6
inches [15 cm] above the floor), call for a trained door systemstechnician.
1
2