Operation Manual
Table Of Contents
- Owner's Manual
- CONTENTS
- Preparation
- Assembly
- Installation
- STEP 1 Determine the header bracket location
- STEP 2 Install the header bracket
- STEP 3 Attach the rail to the header bracket
- STEP 4 Position the garage door opener
- STEP 5 Hang the garage door opener
- STEP 6 Install the light bulbs
- STEP 7 Attach the emergency release rope and handle
- STEP 8 Install the door bracket
- STEP 9 Connect the door arm to the trolley
- STEP 10 Install the door control
- STEP 11 Wire the door control to the garage door opener
- STEP 12 Attach the warning labels
- STEP 13 Install the Protector System®
- STEP 14 Wire the Safety Reversing Sensors
- STEP 15 Connect power
- STEP 16 Ensure the safety reversing sensors are aligned
- STEP 17 Ensure the door control is wired correctly
- Adjustments
- Operation
- Maintenance
- Troubleshooting
- Accessories
- Warranty
- Contact Information
- Repair Parts
- Spanish

31
IMPORTANT SAFETYINSTRUCTIONS
To reduce the risk of SEVERE INJURY or DEATH:
1. READ AND FOLLOW ALL WARNINGS AND INSTRUCTIONS.
2. ALWAYS keep remote controls out ofreach of children. NEVER permitchildren to operate or
playwith garage door control push buttonsor remote controls.
3. ONLY activate garage door when it can be seen clearly,itis properly adjusted,and there are
no obstructions to door travel.
4. ALWAYS keep garage door in sight and away from people and objects until completely
closed. NO ONE SHOULD CROSS THE PATH OF THE MOVING DOOR.
5. NO ONE SHOULD GO UNDER A STOPPED,PARTIALLY OPENED DOOR.
6. If possible, use emergencyrelease handle to disengage trolley ONLY when garage door is
CLOSED. Use caution when using the release with the door opener.Weak or broken springs
or unbalanced door could result in an open door falling rapidly and/or unexpectedlyand
increasing the riskof SEVEREINJURYor DEATH.
7. NEVER use emergencyrelease handle unless garage doorway is clear of persons and
obstructions.
8. NEVER use handle to pull garage door open or closed. If rope knot becomes untied, you
could fall.
9. After ANY adjustments are made, the safetyreversal system MUSTbe tested.
10. Safety reversal system MUSTbe tested every month.Garage door MUST reverse on
contact with 1-1/2" (3.8 cm) high object(or a 2x4 laid flat) on the floor. Failure to adjustthe
garage door opener properly increases the riskofSEVERE INJURY or DEATH.
11. ALWAYS KEEP GARAGE DOOR PROPERLY BALANCED (see page 2). An improperly
balanced door may NOTreverse when required and could result in SEVERE INJURY or
DEATH.
12. ALL repairs to cables,spring assembliesand other hardware, ALL of which are under
EXTREME tension, MUSTbe made by a trained door systemstechnician.
13. ALWAYS disconnect electricpower to garage door opener BEFORE making ANY
repairs or removing covers.
14. This operator system is equipped with an unattended operation feature. The door could
move unexpectedly.NO ONE SHOULD CROSS THE PATH OF THE MOVING DOOR.
15. DO NOT enable the Timer-to-Close functionality if operating either one-piece or
swinging garage doors. To be enabled ONLY when operating a sectional door.
16. SAVE THESE INSTRUCTIONS.
Operation