Operation Manual

35
Operation
Remote Control (continued)
PROGRAM A REMOTE CONTROL USING THE LEARN BUTTON
1. Locate the Learn Button.
2. Press and immediately release the Learn button. The Learn LEDwill glow steady for 30
seconds.Within 30 seconds...
3. Press and hold the button on the remote control that you wish to use.
Release the button when the garage door opener lights blink or two clicks are heard.
When replacing the light lenscover,ensure the antenna wires are hanging straight down.
LEARN LED
LEARN
Button
“click”
“click”
1
2
To Erase the Memory
ERASE ALL REMOTE CONTROLS AND KEYLESS ENTRIES
1. Press and hold the learn button on garage door opener until the learn LED goes out
(approximately6 seconds).All remote control and keyless entrycodes are nowerased.
Reprogram anyaccessoryyou wish to use.
ERASE ALL DEVICES (Including MyQ
®
enabled accessories)
1. Press and hold the learn button on garage door opener until the learn LED goes out
(approximately6 seconds).
2. Immediatelypress and hold the learn button again until the learn LED goes out. All codes are
now erased.
Reprogram anyaccessoryyou wish to use.