Installation Instructions

29
Programming
Your hand-held remote control (model 953ESTD) has already programmed to the door control (myQ Control Panel) at
the factory. Below are instructions for programming additional remote controls, keypads, and myQ enabled accessories
to the door control.
NOTE: Use the learn button on the door control to program all accessories. The yellow learn button on the garage door
opener will NOT program accessories.
PIN
?
?
??
REMOTE CONTROL
1. Press the myQ Control Panel LEARN button twice,
the red learn LED will turn on.
2. Press the button on the remote control that you
wish to operate your garage door.
3. The garage door opener lights will flash (or two
clicks will be heard) when the code has been
programmed.
1. Press the myQ Control Panel LEARN button twice, the
red learn LED will turn on.
2. Enter a 4-digit personal identification number (PIN) of
your choice on the keypad. Then press the ENTER
button.
3. The garage door opener lights will flash (or two clicks
will be heard) when the code has been programmed.
KEYPAD
LEARN
Button
LEARN
Button
Model PILCEV - Remote Light
Control
Light module can be synchronized
with the garage door opener light
bulbs.
Model WSLCEV - Remote Light Switch
Light module can be synchronized with
the garage door opener light bulbs.
myQ ENABLED ACCESSORIES
1. Press the myQ Control Panel
LEARN button twice, the red
learn LED will turn on.
2. Press the LEARN button on
the myQ device.*
* myQ accessories may be programmed to
the Chamberlain
®
Internet Gateway
(Model 041A7665) or the myQ Control
Panel.
Command
LED (yellow)
Learn LED
(Red)
To Add a Remote Control, Keypad, or myQ Enabled Accessories
LEARN
Button
Model AGDMEV - Garage Door and Gate
Monitor
Indicates the status of your garage door
from inside the home and allows you to
close an open garage door from inside the
house.