Instructions / Assembly

ManualsBrandsChamberlain ManualsDoors & WindowsChamberlain Wall Mounted Ultra-Quiet Garage Door Opener

Operation (continued)

FEATURE HOW TO:

PUSH BAR

Press the push bar to open/close the door.

LOCK

Designed to prevent operation of the door from hand-held

remote controls. However, the door will open and close

from the Door Control, keypad, and MyQ App.

Activate: Press and hold the LOCK button for 2

seconds. The command LED will ﬂ ash as long as the

lock feature is activated and your handheld remote

control will not operate your door at this time.

Deactivate: Press and hold the LOCK button again for

2 seconds. The command LED will stop ﬂ ashing and

normal operation will resume.

MOTION SENSOR

This feature will automatically turn on the garage door

opener lights when motion is sensed. The lights will come

on for 4-1/2 minutes, then shut off.

Activate/Deactivate:

Slide the motion sensor switch ON or OFF.

TIMER-TO-CLOSE (TTC)

The TTC feature automatically closes the door after a

speciﬁ ed time period (1, 5, or 10 minutes). Once the

TTC has been set and the door is open, the LED for the

selected close interval will blink and begin to count down

to close the door. The control panel will beep and the

garage door opener lights will ﬂ ash before closing the

door.

The TTC feature will deactivate if the garage door

encounters an obstruction twice; or the safety reversing

sensors are incorrectly installed. The garage door will

reverse open and WILL NOT close until the obstructions

are clear or the safety reversing sensors are correctly

installed. When the obstruction has been cleared or the

safety reversing sensors have been aligned, the door will

close when the garage door opener is activated

Activate: Press and hold the ON button until one of

the TTC LEDs light up. Then press the ON button

again to cycle through the time interval options

(the corresponding TTC LED will light for each time

interval). The garage door opener light bulbs will blink

as conﬁ rmation.

Deactivate: Press and hold the OFF button until all TTC

LEDs turn off and a beep is heard from the control panel.

To suspend the TTC:

To suspend the TTC and temporarily hold the door

open, press and release the HOLD OPEN button (the

HOLD OPEN LED will turn solid). The TTC will remain

suspended until the HOLD OPEN button is pressed again

or the garage door opener is activated from another

device (door control, remote control, keypad, etc.).

Using the Door Control (MyQ

Control Panel)

NOTE: Due to power consumption this door control (Model 041A7928-3) cannot be used in conjunction with another

wired door control connected to your garage door opener. If an additional door control is needed, the wireless door

control model 041A7773-1 can be programmed to the door control (Model 041A7928-3). To program the 041A7773-1

to the MyQ

Control Panel, follow the remote control programming steps.

LIGHT Button

HOLD OPEN Button for the Timer-

To-Close (TTC)

Motion Sensor

Push Bar

1 Minute TTC LED

5 Minute TTC LED

10 Minute TTC LED