Garage Door Opener Owner's Manual

ManualsBrandsChamberlain ManualsGarage Door OpenerSECURITY+ 3265M 1/2 HP

*3-Button Remotes

If provided with your garage door opener, the large

button is factory programmed to operate it. Additional

buttons on any

Security✚

3-Button

remote or compact remote

can be programmed to

operate other Security✚

garage door openers.

To Erase All Codes From Motor Unit

Memory

To deactivate any unwanted remote, first

erase all codes:

Press and hold the “learn” button on

motor unit until the learn indicator light

goes out (approximately 6 seconds). All

previous codes are now erased. Reprogram each

remote or keyless entry you wish to use.

1. Press and hold the button on the

hand-held remote* that you wish to

operate your garage door.

2. While holding the remote button,

press and hold the LIGHT button on

the Multi-Function Door Control.

3. Continue holding both buttons while

you press the push bar on the

Multi-Function Door Control (all

three buttons are held).

4. Release buttons when the motor unit

lights blink. It has learned the code.

If light bulbs are not installed, two

clicks will be heard.

1. Press and release the “learn” button

on the motor unit. The learn indicator

light will glow steadily for 30

seconds.

2. Within 30 seconds, press and hold

the button on the hand-held remote*

that you wish to operate your garage

door.

3. Release the button when the motor

unit lights blink. It has learned the

code. If light bulbs are not installed,

two clicks will be heard.

To Add or Reprogram a Hand-held Remote Control

USING THE “LEARN” BUTTON USING THE MULTI-FUNCTION DOOR CONTROL

LOCK

LIGHT

LOCK

LIGHT

PROGRAMMING

Your garage door opener has already been programmed at the factory to operate with your hand-held remote control.

The door will open and close when you press the large push button.

Below are instructions for programming your opener to operate with additional Security✚

remote controls.

NOTICE: If this Security✚

garage door opener is operated with a non-rolling code transmitter, the technical measure in

the receiver of the garage door opener, which provides security against code-theft devices, will be circumvented. The

owner of the copyright in the garage door opener does not authorize the purchaser or supplier of the non-rolling code

transmitter to circumvent that technical measure.

LOCK

LIGH