Installation Guide

Tough Cover

MODEL TC1000

To reduce the risk of SERIOUS INJURY or DEATH:

• READ AND FOLLOW ALL INSTRUCTIONS.

• NEVER let children operate or play with door controls. Keep

the remote control away from children.

• ALWAYS install the proper safety reversing sensors.

• Without a properly installed safety reversing sensor, persons

(particularly small children) could be SERIOUSLY INJURED

or KILLED by a closing garage door.

To avoid personal INJURY or DAMAGE to property:

• Avoid sharp edges when cutting to size.

• NEVER allow children to play with small pieces during

installation.

OVERVIEW

Tough Cover keeps safety reversing sensors aligned and protected. Tough Cover may be attached to the door track, wall, or floor. If the

safety reversing sensors are mounted to the floor, fasten Tough Cover to the floor using concrete screws (not provided). Tough Cover

may be trimmed with standard snips to fit around an obstacle.

NOTE: The safety reversing sensors MUST be connected and aligned correctly. The sensors should be no more than 6 inches (15 cm)

above the floor.

Position Tough Cover over the safety reversing sensor and

fasten to the wall with lag bolts.

Fasten Tough Cover to the garage door track with carriage

bolts, nuts, and washers.

Test the safety reversing sensors according to the manufacturer’s instructions.

INSTALLATION

PAGE 1
Tough Cover MODEL TC1000 To reduce the risk of SERIOUS INJURY or DEATH: • READ AND FOLLOW ALL INSTRUCTIONS. • NEVER let children operate or play with door controls. Keep the remote control away from children. • ALWAYS install the proper safety reversing sensors. • Without a properly installed safety reversing sensor, persons (particularly small children) could be SERIOUSLY INJURED or KILLED by a closing garage door. To avoid personal INJURY or DAMAGE to property: • Avoid sharp edges when cutting to size.
PAGE 2
Tapa dura MODELO TC1000 ADVERTENCIA PRECAUCIÓN Para reducir el riesgo de LESIONES GRAVES o la MUERTE: • LEA Y APLIQUE TODAS LAS INSTRUCCIONES. • NO permita que los niños jueguen ni usen un control de puerta. Mantenga el control remoto alejado del alcance de los niños. • Instale SIEMPRE los sensores de seguridad para inversión de dirección.