Installation Guide

INSTALLATION AND CONNECTION

SELECTING THE ROOM

• Install the appliance in a dry and well ventilated room. Ambient temperature should never be lower than

41 °F.

Warning: Make sure the room where the appliance is installed is large enough. There should be at

least 1 m

of space per 8 grams of refrigerant. Amount of refrigerant is stated on the rating plate in the

appliance interior.

INSTALLING THE APPLIANCE

Appliance installation should be carried out by

at least two persons to avoid any physical injury

or damage to the appliance.

• The appliance must stand level or tilted

slightly to the back, stable on a solid base. At

the front, the appliance is fitted with two

adjustable legs that can be used to level the

appliance. At the rear side, casters allow for

easier installation of the appliance (only with

some models).

• There should be a clearance of at least 5 cm

between the appliance and any cupboard

installed above it, to allow adequate cooling of

the condenser unit.

• The appliance is supplied with two spacers

which should be installed on the lower part

of the housing to prevent from pushing the

appliance too close to the wall. Appliance

may also be installed without the spacers;

however, this may increase power

consumption.

• Do not expose the appliance to direct

sunlight and do not place it near any source

of heat. If this cannot be avoided, install an

insulation panel.

max

30 mm

514483

PAGE 1
INSTALLATION AND CONNECTION SELECTING THE ROOM • Install the appliance in a dry and well ventilated room. Ambient temperature should never be lower than 41 °F. Warning: Make sure the room where the appliance is installed is large enough. There should be at least 1 m3 of space per 8 grams of refrigerant. Amount of refrigerant is stated on the rating plate in the appliance interior.
PAGE 2
• The appliance may stand alone, or it may be placed next to a cupboard or a wall. Consider the clearance required to fully open the door to allow pulling out the drawers and shelves (see installation diagram). min 50 mm ma x 90 ° 1224 mm 1176 mm 669 mm 717 mm 600 mm 710 mm CONNECTING THE APPLIANCE • Connect the appliance to the power mains using a connection cable. The wall outlet should be fitted with a ground contact (safety socket).