Owner's manual

First time users

Set up of the Model 7602 MKII

1- Select 40 dB on the Microphone / Line sensitivity

control. Turn the Output control fully counter

clockwise. Make certain that the DI, 48V, EQ and

Phase switches are all off.

2- Connect a microphone to the Female XLR plug on

the rear panel. If the microphone requires Phantom

Power, switch the 48V on. The normal position for the

300/1.2K Ohm switch is 1.2K. This matches most

professional microphones used today; if you have

microphones that require a lower impedance you may

toggle the switch to 300. You can toggle between the

selections without damage to the microphones to

determine which impedance performs better for your

application.

3- Connect the male, Line Output XLR connector,

located on the rear panel to the input XLR on your

recorder or D.A.W.

(If you are sending to a device that does not have a gain

control, use the Output control to adjust your signal so

that your loudest signals just fail to reach the maximum

input levels on your recording device.)