User's Manual

Installation

Installation (continued)

Unpacking (continued)

6. Use 2 people to move the machine in order to install the legs.

7. Have 1 person behind the glasswasher tilt it back as the person in front twists the machine

to the right. This makes the front left leg mounting hole accessible.

8. Screw 1 of the legs tightly into place. Repeat this process for the remaining legs.

9. Lift the glasswasher off the pallet, and re-install the front door..

10. Level the glasswasher front-to-back and side-to-side by adjusting the leg bullet feet in or out.

11. Comparethesiteutilitieswiththedataplatespecications.Ifthey

agree, then proceed with the installation according to the diagrams on the next page.

12. Remove the packing material in the glasswasher and discard, then

removeanyprotectivelmonthemachine.

Twist the

glasswasher

to the right,

then to the left.

TILT

6"-7½"

1½"

Level front-to-back and side-to-side

Thread (1) leg in each

corner of the

machine base

Tilt the machine back to clear

plumbing connections.

Twist the machine to the right until the front right leg mounting

hole is accessible.

Make sure to install the legs tightly.