User's Manual

8
Operation
Filling the Wash Tank
• Ensure that the overflow drain tube is in place in the detergent tank.
• Flip power on-off/flush switch to the “ON” position. The water will fill until the proper level is
reached then turn the heating element “ON”.
• The water temperature is controlled by a heater and a thermostat .The thermostat should be set
for minimum 140°F/60°C.
Operating Instructions
• Open the door; flip power on-off/flush switch to the “ON” position. Wash tank will automatically fill.
• Ensure there is product in the detergent, sanitizer and rinse agent containers.
• Detergent is fed from the supply container into the detergent tank in controlled amounts by the
detergent pump. Use detergent at strength recommended by your chemical supplier.
• Load glasses on the conveyor. The glass washer conveyor will start and stop with the conveyor
shut-off (Plexi-glass Divider) switch.
Assembling the Glasswasher
• Make sure the power switch is in the OFF position.
• Install the wash arms and rinse spray arms. The spray arms have locating notches
in the end of each arm. Push the spray arm straight into the hub. Do not twist.
• Install the conveyor assembly as follows:
Insert the conveyor into the wash chamber keeping the rear raised.
Pull the conveyor forward until it meshes with the drive gear located at the front
of the wash chamber.
Continue to pull the conveyor forward as you lower it on the pivot.
• Install the stainless steel cylinder in the center of the conveyor.
• Install the conveyor shut-off assembly (plexiglass divider).
• Install the right and left hand tray.
• Install the curtain assembly.
• Install the upper and lower scrap screens.
• Install the standpipe in the detergent tank.
Twist slightly to make sure it seats securely in the drain.
• Install the drain tray/waste collector (if equipped).
Make sure the drain fitting is secure.
• Make sure the chemical supply containers are full.
• Close the door.
Operation (continued)