User's Manual

10
Troubleshooting
The following troubleshooting guide can help identify a problem and provide a solution.
Inspectyourglasswasherbeforeyoucontactanauthorizedservicerepresentative.
GlasswasherwillnotturnON.
Conveyor will not rotate.
Conveyor will not stop
rotating.
Conveyor rotates in
wrong direction.
Upper scrap screen is
hard to remove.
Front door will not close
remain closed.
Glasswasher not level
or rocks back and forth.
Main breaker/fuse box OFF
Disconnect fuse blown/breaker
tripped.
GlasswasherON/OFFswitch
OFF. Power cord unplugged.
Clean glass(es) touching the
conveyor shut-off switch.
Conveyor center hub out of
position.
Conveyor support(s) out of
position and/or broken.
Drive gear out of position.
Gear teeth on conveyor worn
or broken.
Gear teeth on drive gear worn
or broken.
Object jamming the conveyor.
Conveyor drive motor
defective.
Conveyor stop switch
needs adjustment or
switch is defective.
The drive motor
is turning the conveyor
backward.
Large debris, such as
broken glass is on screen.
Scrap screen bent and/or broken.
Door magnet broken or missing.
Door bent or broken.
Floor is not level.
Leg(s)arenotscrewedrmly
into machine base.
Problem Cause(s) Solution(s)
Turnbreaker/fuseboxON.
Turnbreaker/fuseboxON.
Replace fuse/Reset Breaker.
FlipON/OFFswitchON.
Plug-in power cord.
Remove clean glasses from the
rinse-side of the glasswasher.
Reposition the conveyor.
Reposition or replace support(s).
Reposition drive gear.
Replace the conveyor.
Replace drive gear.
Remove object.
Tighten leg(s) or replace.
Use bubble level and turn bullet
feet in/out to adjust machine level.
Straighten or replace door.
Authorizedserviceagentmay
replace conveyor drive motor.
AuthorizedServiceAgentmay
adjust or replace switch.
AuthorizedServiceAgent
may remove drive motor
rotate motor stator 180° and
re-install.
Remove conveyor and lower
spray arm(s). Remove debris.
Replace door magnet.
AuthorizedServiceAgentmayrepair
or replace damaged screen.