Use and Care Manual

ManualsBrandsChampion Power Equipment ManualsTools & Hardware2,200 lb. 12-Volt ATV/UTV Winch Kit

1

2

3

4

5

6

7

8

9

REV 100127-20140821 6

100127 ENGLISH

ASSEMBLY

Assembling the Winch

This CPE 2200 lb. (998 kg) winch is designed

with a bolt pattern that is standard in this class

of winch. Many winch mounting kits are available

that utilize this bolt pattern for the most popular

UTVs and ATVs. If you cannot ﬁnd a kit locally,

contact CPE and we will provide you with the

name of a dealer.

The type of vehicle to which the winch and

mounting channel will be applied, will dictate

the type of mounting kit that should be used

(Speed Mount™ Hitch Adapter, Standard

Mounting Channel, or Specialty Mounting Kit).

NOTE

If utilizing a mounting plate, ensure that

the three major sections (motor, drum and

gear housing) are properly aligned. Proper

alignment of the winch will allow for even

distribution of the full rated load.

CAUTION

Mounting bolts must be SAE grade 5 or better

and torque to 34 ft. lbs.

CAUTION

Assembling the Winch Cont’d.

Mounting the Remote control

1. The remote control is usually installed on the

left handlebar.

2. Use a piece of electrical tape around the

handlebar to help prevent rotation of the

mount on the handlebar. Do NOT tighten over

any hoses or cables.

3. Once the remote control is mounted you can

route the wires back to the battery and winch.

4. Make sure the handlebars have full range of

motion and then secure the remote control’s

cable.

1. Insert M8x20 bolts through the mounting

channel hole and attach the roller fairlead

to the mounting channel with the M8

ﬂat washer, M8 lock washer, and M8 nut

provided.

2. To attach the winch and the mounting

channel to a ﬂat surface; insert M8x35 bolt

through the winch base plate, then through

the mounting channel, then through a ﬂat

mounting surface. Secure the winch and

mounting channel with the M8 ﬂat washer,

M8 lock washer, and M8 nut provided.

3. Disengage the clutch by pulling and rotating

the clutch knob to the “Out” position.

Release the wire rope and pull through the

roller fairlead.

4. Attach the clevis hook to the cable, and then

hand strap to the clevis hook.