Warranty

ENGLISH 100236

ASSEMBLY

12.5

其余

3) Install the Tow Bar and Support Leg

1. Attach the tow bar to the bracket on the bottom of

the splitting beam opposite the axle. Secure with

two (2) M12x80 bolts and M12 lock nuts. (A)

4) Install the Hydraulic Hose (Tank)

1. Using a clamp d25, connect and secure the

hydraulic hose to the back of the beam/base of the

tank. (A)

2. Leave the other end of hose unconnected at this

time.

5) Install the Engine and Hydraulic Hose (pump)

1. Place the engine on the engine bracket with the pump

facing the cylinder. (A)

2. Line up the holes in the base of the engine and secure

the engine with four M8x40 bolts, M8 washers, M8 lock

washers and M8 nuts. Tighten to 18 ft-lb. (A)

2. Attach the support leg to the same bracket on

the bottom of the splitting beam. Secure with one

M12x80 bolt and M12 lock nut. (B)

3. Secure the support leg in the vertical/horizontal

position by inserting the L-pin through the bracket

and support leg and securing with hair pin clip. (C)

Do not tow with support leg in the down position

or if loose. The support leg must be locked in the

upright position before towing. Towing the unit with

the support leg in the down position or loose may

cause property damage and/or injury.

WARNING

3. Connect the oil pipe to the connection on the bottom of

the pump. Secure with the d25 clamp. (B)

4. Connect the other end of the oil pipe to the connection

on the base of the beam/tank. Secure with the d25

clamp. (C)

C C