Operating Guide

100261 ENGLISH

Economy Control Switch

The Economy Control switch can be activated in order to

minimize fuel consumption and noise while operating the

unit during times of reduced electrical output, allowing

the engine speed to idle during periods of non-use. The

engine speed returns to normal when an electrical load is

connected. When the economy switch is off, the engine

runs at normal speed continuously.

If the battery is dead or not able to produce enough

current to power the push button choke, the choke itself

can be operated manually to help start the engine. To

manually choke and start the inverter, follow these steps:

1. Loosen the screws and remove the maintenance

cover. (A)

For periods of high electrical load or momentary

ﬂuctuations, the Economy Control Switch should be

turned OFF.

WARNING

Manual Choke Start Cont’d.

OPERATION

Manual Choke Start

2. Locate the yellow manual choke lever. (B)

3. Turn the choke lever to the “CHOKE” (right)

position. (B)

4. Turn the fuel valve to the “ON” position.

5. Turn the engine switch to the “ON” position.

6. Pull the recoil rope until resistance is felt, then pull

rapidly.

7. As the engine starts to roll over, move the choke lever

to the “RUN” (left) position.

Keep choke lever in “Choke” (right) position for only

1 pull of the recoil starter. After ﬁrst pull, move the

choke lever to the “Run” (left) position for up to the

next 3 pulls of the recoil starter. Too much choke

leads to spark plug fouling/engine ﬂooding due to

the lack of incoming air. This will cause the engine

not to start.

NOTE