Operating Guide

17
ENGLISH 100261
OPERATION
Wireless Set Button
The wireless set button is a feature that lets the user
sync remotes to the generator. One can set up to two
remote controls or reset a remote control with the
generator. To reset a remote control or sync two remote
controls follow these steps:
1. Turn the ignition switch to the “ON” position.
2. Turn the battery switch to the “ON” position.
3. Push and hold the wireless set button next to
the red light (located on the front panel) for
approximately three seconds; the red light will turn
on.
4. Push and release the “STOP” button on the remote.
The red light blinks once to erase the remote
program.
5. Push and release the START button. The red light
blinks once to program the remote.
6. Push and hold the programming button
approximately three seconds until the red light turns
off.
7. Test Start & Stop features
Only two remote controls can be in sync with one
generator at a time.
NOTE
Changing a remote control battery may not require
the user to reset the remote control.
NOTE
Parallel Operation
Two (2) Champion model 100261 generators can
be operated in parallel to increase the total available
electrical power. A Champion parallel kit (optional
equipment) is required for parallel operation. For kit
availability, call customer service at 1-877-338-0999 or
visit www.championpowerequipment.com.
Detailed instructions for parallel kit installation, operation,
and rating of the connected generators are provided in the
parallel kit owner’s manual and operating instructions.