Operating Guide

8
100263 ENGLISH
Power Panel
(1) Fuel Selector Switch – Used to select and turn on
gas or LPG fuel source.
(2) LPG Hose Quick Connect Inlet
(3) Choke
(4) Smart Charger 12V DC
(5) Ground Terminal – Consult an electrician for local
grounding regulations.
(6) 12V DC Outlet*
(7) Parallel Outlets – used for parallel operation.
(8) 120 Volt AC, 20 Amp Duplex
(NEMA 5-20R) –
May be used to supply electrical power for the
operation of 120 Volt AC, 20 Amp, single phase
60 Hz electrical loads.
(9) Circuit Breaker (push-button) – Protects the
generator against electrical overload.
CONTROLS AND FEATURES
1516 11 10
3
4
5
6
8
2
1
(10) Battery Switch
(11) 120 Volt AC, 30 Amp Receptacle (NEMA TT-30R)
–
May be used to supply electrical power for the
operation of 120 Volt AC, 30 Amp, single phase
60 Hz electrical loads.
(12) Oil Warning Light – Check oil level when this light
turns on. Engine will not run when indicator is lit.
(13) Overload Indicator Light – This light turns ON
when the generator is overloaded and will cut
power to the receptacles.
(14) Output Light – Remains ON during normal
operating conditions. Shuts OFF when generator is
overloaded.
(15) Ignition Switch
(16) Economy Control Switch
*Warning: Do not operate a device while it is plugged into the 12V DC outlet. Prolonged exposure to engine exhaust can cause
serious injury or death. While charging a device do no place on the exhaust side of the generator. Extreme heat caused by exhaust
can damage the device, and cause a potential fire hazard.
9
7
12
14
13
9