Use and Care Manual

100380 - REAR TINE TILLER

ASSEMBLY

Install the Tine Shield

1. Remove the (4) M10×25 mm ﬂange head bolts installed in

the tine shield brackets above the transmission housing.

2. Place the tine shield on the bracket and secure with the

bolts removed in step 1.

Install the Depth Regulator

1. Remove the (1) pin and (1) clip from the depth regulator

lever.

2. Insert the depth regulator into the bottom of the depth

regulator bracket.

3. Insert the pin through the bracket and lever.

4. Install the clip removed in 1 onto the depth regulator lever.

Attach Upper Handle

1. Slide the upper handle down over the lower handle and

align the holes.

2. Insert the (4) M8×50 curved head bolts into the holes as

shown and securely with the (4) handle knobs and (4) ﬂat

washers.

3. Tighten the handle knobs securely.

Attach Speed Control

1. Attach speed control using provided (1) M6 bolt, (1)

washer, and (1) M6 nut.

2. Tighten completely.

3. Use plastic clips to secure the cables as shown.

Attach Front Bumper

1. Slide the front bumper onto the outside of the base frame

and align the holes.

2. Install the (4) M8×25 mm bolts and (4) M8 lock nuts and

tighten securely.