Use and Care Manual

ManualsBrandsChampion Power Equipment ManualsGeneratorsDH Series 6,250-Watt Gasoline Powered Recoil Start Open Frame Inverter Generator with 301 cc Engine

100519 - 6250W PORTABLE INVERTER GENERATOR

CONTROLS AND FEATURES

FCC Statement

1. This device complies with Part 15 of the FCC Rules.

Operation is subject to the following two conditions:

1a. This device may not cause harmful interference.

1b. This device must accept any interference received,

including interference that may cause undesired

operation.

2. Changes or modiﬁcations not expressly approved by the

party responsible for compliance could void the user’s

authority to operate the equipment.

! NOTICE

This equipment has been tested and found to comply with

the limits for a Class B digital device, pursuant to Part 15

of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a

residential installation. This equipment generates uses and

can radiate radio frequency energy and, if not installed

and used in accordance with the instructions, may cause

harmful interference to radio communications. However,

there is no guarantee that interference will not occur in a

particular installation. If this equipment does cause harmful

interference to radio or television reception, which can be

determined by turning the equipment off and on, the user is

encouraged to try to correct the interference by one or more

of the following measures:

– Reorient or relocate the receiving antenna.

– Increase the separation between the equipment and

receiver.

– Connect the equipment into an outlet on a circuit

different from that to which the receiver is connected.

Consult dealer or an experienced radio/TV technician for help.

Parts Included

Accessories

Flexible Oil Funnel .................................................................1

Dual 2.4A Port USB Adapter ..................................................1

Battery Charging Cables ........................................................1

Assembly Parts

Wheels

8 in. (20.3 cm) Never Flat Wheel (A) ..................................2

Roll Pin (B)........................................................................2

Large R-clip (C) ................................................................2

Engine Vibration Mounts

Support Leg with Vibration Mounts (D) ..............................1

Flange Bolt (M8×16) (E) .................................................... 2

Flange Lock Nut (M8) (F) ..................................................2

Folding Handle

Handle (G) ........................................................................1

Flange Bolt (M6×30) (H) ...................................................4