Use and Care Manual

100519 - 6250W PORTABLE INVERTER GENERATOR

ASSEMBLY

Your generator requires some assembly. This unit ships from

our factory without oil. It must be properly serviced with fuel

and oil before operation.

If you have any questions regarding the assembly of your

generator, call our Technical Support Team at 1-877-338-0999.

Please have your serial number and model number available.

Unpacking

1. Set the shipping carton on a solid, ﬂat surface.

2. Remove everything from the carton except the generator.

3. Carefully cut each corner of the box from top to bottom.

Fold each side ﬂat on the ground to provide a surface area

to work with the generator.

Install the Wheel Kit

! CAUTION

The wheel kit is not intended for over-the-road use.

Install the Wheels

1. Before adding fuel and oil, tip the generator onto it’s end.

2. Slide the roll pin (B) through the wheel (A) from the outside.

3. Slide the roll pin through the mount point on the frame.

4. Secure with the R-clip (C).

5. Repeat to attach the second wheel.

Install the Support Leg

1. Attach the support leg (D) to the generator frame with

ﬂange bolts (E) and ﬂange lock nuts (F).

2. Slowly tip the generator back down so that it rests on the

wheels and support leg.

Install the Handle

1. Place the handle (G) over the mounting channel on the

frame.

2. Secure the handle to the frame using the four ﬂange

bolts (H).