Full Product Manual

ManualsBrandsChampion Power Equipment ManualsGenerators3500-Watt Gasoline Powered RV Ready Portable Generator with Wireless Remote Start (EPA)

100558 - 3500W WIRELESS START GENERATOR

MAINTENANCE

Manual Stop

1. Turn off and unplug all electrical connected loads. Never

start or stop the generator with electrical devices plugged

in or turned on.

2. Let the generator run at no-load for several minutes to

stabilize internal temperatures of the engine and generator.

3. Press the ignition switch to the “OFF” position.

4. If generator was started electrically, press the battery

switch to the “OFF” position.

5. Turn the fuel valve to the “OFF” position.

NOTICE

If the engine will not be used for a period of two (2) weeks or

longer, please see the Storage section for proper engine and

fuel storage.

MAINTENANCE

Make certain that the generator is kept clean and stored

properly. Only operate the unit on a ﬂat, level surface in a clean,

dry operating environment. DO NOT expose the unit to extreme

conditions, excessive dust, dirt, moisture or corrosive vapors.

! WARNING

Never operate a damaged or defective generator.

! WARNING

Improper maintenance will void your warranty.

NOTICE

For Emission control devices and systems, read and

understand your responsibilities for service as stated in the

Emission Control Warranty Statement of this manual.

The owner/operator is responsible for all periodic maintenance.

Complete all scheduled maintenance in a timely manner.

Correct any issue before operating the generator.

For service or parts assistance, contact our

Technical Support Team at 1-877-338-0999.

Cleaning the Generator

! CAUTION

DO NOT spray generator directly with water.

Water can enter the generator through the cooling slots and

damage the generator windings. It can also contaminate the

fuel system.

1. Use a damp cloth to clean exterior surfaces of the

generator.

2. Use a soft bristle brush to remove dirt and oil.

3. Use an air compressor (25 PSI) to clear dirt and debris

from the generator.

4. Inspect all air vents and cooling slots to ensure that they

are clean and unobstructed.

To prevent accidental starting, remove and ground the spark

plug wire before performing any service.